350 Watt grid tie inverter
For Solar & Wind systems
Newest Generation Model including LED display!
Stackable! Connect in parallel for higher output!
We are the proffessional manufacturer, pls feel free to contact us if you have any problem about purchase!
| Brand |
LS |
| Model |
LS-350W |
| Continuous Output Power |
350W |
| Output Wave Form |
PURE SINE WAVE |
| DC Input Voltage |
DC 14 Volt – 28Volt(solar panel) |
| AC Output Voltage |
AC 95v-130v/ 190v-260v
|
| Frequency |
46Hz-65Hz |
| Peak Efficiency |
94%
|
| No Load current Draw |
0.5A |
| Total Harmonic Distortion(THD) |
<5% |
| Temperature Protection |
-10 0C ~ 45 0C
|
| Net Weight |
1.5kgs |
| MPPT Function |
Yes |
| Over Current Protection |
Yes |
| Over Temperature Protection |
Yes |
| Reverse Polarity Protection |
Yes |
Unique and intuitive display design
LED fault display
External 20A Fuse, easy maintenance
Reverse polarity protection
Please note: This inverter only has gird tie inverter function, without traditional inverter function
so please DO NOT connect 12V DC battery.
Feature:
- Reverse polarity protection. When connect incorrect AC input, inverter will alarm to avoid damage.
- The DC input will cut off auto at night to avoid the current regorge. And switch on when there is DC come in at daytime.
- Maximum Power Point Tracking (MPPT) - optimize power output
- Stackable (connect in parallel for higher output)
- Island protection: Inverter will shut down during black outs.
- LED indicators to reflect power output rate
- Grid-Tied - sell green power directly back to the grid at a premium rate (depends on your location)
- Generates pure Sine Wave
- Plug and Play Design, simply plug into an outlet (GFI), no hard-wiring
- Simple and safe installation
- Constant Power Output
- Low distortion output on all ranges
- Allow different Power factor from loads
- Does not require rewiring of existing electronics
- Compact and light weight design
1. Install in a low humidity and well-ventilated area. Remove all flammable objects.
2. Connect the solar panel or Wind Turbine's DC supply cables to the DC input terminal of the inverter as shown the above picture,
Wind Turbine installations will require respective charge controller and dump loads.
3. Connector the inverter to a wall socket with supplied AC power cord.
This inverter is stackable, and all inverters are independent each other. The total power converting to the grid is the total power of all inverters. The installation of each is same.
msn1
